--- title: "How to Automate a Diesel Irrigation Pump with the Verdi Block Controller and Murphy TEC-10" slug: "diesel-irrigation-pump-control" updated: 2025-05-23T17:29:57Z published: 2025-05-23T17:29:57Z canonical: "docs.verdi.ag/diesel-irrigation-pump-control" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.verdi.ag/llms.txt > Use this file to discover all available pages before exploring further. # How to Automate a Diesel Irrigation Pump with the Verdi Block Controller and Murphy TEC-10 To control a diesel engine-powered irrigation pump using the Verdi Block Controller in conjunction with a Murphy PowerCore® TEC-10 controller, follow these steps: ## Introduction Verdi Block Controller: A wireless, battery-powered device designed for remote control and monitoring of irrigation systems. It can deliver a pulse output, and when paired with a dry contact relay, effectively simulates a level switch to trigger external controllers.  Murphy PowerCore® TEC-10: An electronic controller that provides comprehensive engine management, including auto start/stop and auto throttling. It supports various input configurations, including digital inputs for start/stop functions. [https://support.enovationcontrols.com/hc/en-us/articles/115006311508-PowerCore-TEC-10-for-Engine-Controls](https://support.enovationcontrols.com/hc/en-us/articles/115006311508-PowerCore-TEC-10-for-Engine-Controls) ## Integration Steps For detailed wiring diagrams and configuration settings, refer to the respective user manuals of the Verdi Block Controller and the Murphy PowerCore® TEC-10 controller. 1. Connect the Verdi Block Controller to the TEC-10 Controller Wire the Verdi Block Controller’s pulse output to the Verdi Pump Relay and then wire the Pump Relay to one of the TEC-10’s digital inputs configured for start/stop control. 2. Program the TEC-10 Controller Access the TEC-10’s settings and configure the relevant digital input to respond to the short-circuit signal from the Verdi Block Controller and Pump Relay. Set the TEC-10 to initiate engine start upon receiving the short-circuit signal and to stop the engine when the signal ceases. 3. Testing and Validation Press the water on button on the Verdi Block Controller to send a pulse signal. Verify that the TEC-10 responds appropriately by starting the engine. Ensure that stopping the pulse signal results in the engine stopping, if configured to do so.