--- title: "Heat and Frost Protection" slug: "heat-and-frost-protection" updated: 2026-09-25T01:29:04Z published: 2026-09-25T01:29:04Z canonical: "docs.verdi.ag/heat-and-frost-protection" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.verdi.ag/llms.txt > Use this file to discover all available pages before exploring further. # Heat and Frost Protection *This feature is available, but in beta.* ## Introduction Heat and frost protection uses [Sensor-Driven Automation](/v1/docs/sensor-driven-automation) with an air temperature sensor. The Verdi Block Controller or Verdi Micro-Block Controller opens its valve when the air temperature crosses the ***Target*** you set. > [!CAUTION] > Important note > > Heat and frost protection is currently wired and on-device only. A temperature sensor protects only the zone whose controller it is wired into. ## Before You Start - Each zone you want to protect needs its own temperature sensor wired into that zone's controller. One sensor cannot open valves on other controllers or start a protection sequence across several zones. - Automation will not turn on a pump controlled by another controller, including a parent pump controller linked to the zone (see [Pump Control](/v1/docs/pump-control)). Make sure the zone has water pressure when its valve opens. - Position each temperature sensor so it represents conditions in the zone it protects. ## How to Set Up 1. Wire an air temperature sensor into the controller for the zone you want to protect. 2. Follow the steps in [Sensor-Driven Automation](/v1/docs/sensor-driven-automation), selecting the temperature sensor in the ***Sensor*** dropdown and setting a temperature ***Target***. 3. Set ***Irrigate Below Threshold*** for the type of protection: - Frost protection: enable (green). The valve opens when the temperature drops below the ***Target***. - Heat protection: disable (grey). The valve opens when the temperature rises above the ***Target***. 4. Click ***Save***, then repeat on every controller that needs protection. ## Wireless Heat and Frost Protection (Roadmap) Using one temperature sensor to start a protection sequence across several zones and a pump requires wireless sensor-driven automation. This is on the Verdi roadmap but does not have a release date yet. See [Sensor-Driven Automation](/v1/docs/sensor-driven-automation) for details.