--- title: "Pressure Verification Kit" slug: "pressure-verification-kit" updated: 2026-05-09T20:21:48Z published: 2026-05-09T20:21:48Z canonical: "docs.verdi.ag/pressure-verification-kit" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.verdi.ag/llms.txt > Use this file to discover all available pages before exploring further. # Pressure Verification Kit The Verdi Pressure Sensor Kit for [Block Controller](/v1/docs/block-controller) enables accurate, real-time verification of system pressure through the Block Controller. It uses a high-quality Honeywell sealed pressure transducer to measure line pressure and report values back to the Verdi Dashboard, allowing operators to confirm that the system is pressurized as expected during and after irrigation events. ![](https://cdn.document360.io/21bcacda-1800-45ee-8df3-7d1d6186e001/Images/Documentation/image(256).png?sv=2026-02-06&spr=https&st=2026-11-19T04%3A38%3A15Z&se=2026-11-19T05%3A38%3A15Z&sr=b&sp=r&sig=Z5swZozsIHutG0AZ9vqS269tjG9IIxy14SYHxpBax7s%3D) ## What's Included The Pressure Verification Kit comes with the following components: - **Pressure Transducer** - Honeywell 150 PSI Sealed pressure transducer - **Connector Cable** - A pre-terminated cable with connectors on both ends: one end plugs directly into the pressure transducer, and the other end plugs into the Block Controller. - **Glue-On Saddle with 1/2”→1/4” NPT bushing (Optional)** The kit is designed for fast, tool-free installation and easy replacement in the field. ## Referenced Pressure Transducer **Manufacturer:** Honeywell **Pressure Range:** 0–150 PSI **Type:** Sealed gauge **Process Connection:** 1/4–18 NPT ### Mechanical Specifications | Specification | Value | | --- | --- | | Seal type | Pipe thread | | Mating geometry | ANSI B1.20.1 | | Installation torque | Two to three turns from finger tight | | Weight | 38 g [1.3 oz] | | Overall length | 50.0 mm [1.97 in] | | Hex diameter | 17.0 mm [0.67 in] | ### Dimensional Drawing ![](https://cdn.document360.io/21bcacda-1800-45ee-8df3-7d1d6186e001/Images/Documentation/image-1778358101456.png?sv=2026-02-06&spr=https&st=2026-11-19T04%3A38%3A15Z&se=2026-11-19T05%3A38%3A15Z&sr=b&sp=r&sig=pOe%2Fx3zzbIaheamf0aogxtzGe6oj%2FzUseM4mx7hEaco%3D) ## Installation Notes > **Important:** Any NPT sensor, including this pressure transducer, should only be tightened **two to three turns past finger tight**. Over-tightening an NPT fitting can crack the fitting body, damage the transducer, or compromise the seal. After installing the transducer into the NPT port on the valve, or glue-on saddle, connect one end of the supplied cable to the transducer and the other end to the Block Controller sensor input. The connectors are keyed for correct orientation.